Patton electronics SmartNode Series Software Configuration Manual page 86

7 • Configuration file handling
Example: Replacing the startup configuration with a configuration from Flash memory
The following example shows how to overwrite and therefore replace the persistent startup configuration in the
flash memory of a SmartNode with the configuration contained in the file new-startup already present in the
flash memory.
1. Replace the current startup configuration, using the copy command, into the flash memory area where the
startup configuration has to be stored.
SN#copy nvram:new-startup startup-config
2. Check the content of the persistent startup configuration by listing its command settings with the show
command.
SN#show startup-config
Startup configuration:
#----------------------------------------#
# SmartWare R2.00 BUILD220
# 2001-10-25T09:20:42
# Generated configuration file
#----------------------------------------#
cli version 2.00
snmp community public rw
framerelay
exit
SN#
84
SmartWare Software Configuration Guide
#
#
#
Configuration file handling task list