Patton electronics SmartNode Series Software Configuration Manual page 287

SmartWare Software Configuration Guide
Note You can modify the configuration at runtime, but changes will not be active
immediately. It is not necessary to shutdown the CS context prior to making
any configuration changes, but if the CS context is not activated with the
command no shutdown the newly created or changed configuration is not
loaded!
There are several possibilities to show the actual CS context configuration. Note that some of the show com-
mands display only the actual configuration. It could be that you have changed your configuration and it is not
displayed because the configuration is reloaded. For more information on the show command refer to the
respective configuration chapters or to chapter 31,
This procedures describes how to show the CS context configuration, enable the Session Router debug moni-
tor and activate the CS context
Mode: Context CS
Step
1 node (ctx-cs)[switch]#show context cs config level Show the CS context configuration. Level
node (ctx-cs)[switch]#debug session-router
2
node (ctx-cs)[switch]#no shutdown
3
Example: Enable CS context
The following example shows how to disable the current CS context configuration, how to enable the Session
Router debug monitor and how to enable the CS context. It also shows the output from the Session Router
debug monitor.
Note The interface callapp is a default interface, that is always defined and cannot
be deleted.
SN(cfg)#show context cs config 5
Following session-router configuration sets are available:
switch
Interfaces:
H323_IF
ISDN
SN(cfg)#debug session-router 5
SN(cfg)#context cs
SN(ctx-cs)[switch]#no shutdown
SN(ctx-cs)[switch]#00:01:39
00:01:39 SR
00:01:39 SR
00:01:39 SR
00:01:39 SR
00:01:39 SR
00:01:39 SR
00:01:39 SR
CS context configuration task list
Command
SR
> Resolving interface references interfaces...
> Classifier is resolving interface references...
> Loading session router tables...
> Resolving routing table references within routing tables...
> Resolving interface references within routing tables...
> Resolving routing table references within interfaces...
> Classifier is resolving session router
"VoIP debugging" on page 395.
could be 0..5. Level 0 shows less, level
5 shows all information.
Enable the session-router debug monitor
Enable the CS context, checks the inter-
face and session router configuration
> Loading interfaces...
23 • CS context overview
Purpose
references...
285