Create A Time Of Day Routing Table - Patton electronics SmartNode Series Software Configuration Manual

25 • Session router configuration
The BC value may therefore not be a reliable indication to differentiate
between analogue speech, audio or Fax Group 3 connections.
The session router can route calls according to the following bearer capabilities:
• ItcAudio31: Transparent 3.1kHz channel
• ItcSpeech: Voice terminals (Telephones)
• ItcUD64: Unrestricted digital information (64 kbps)
• ItcRD64: Restricted digital information (64 kbps)
This procedure describes how to create a bearer capability routing table
Mode: Context CS
Step
1 node (ctx-cs)[ switch ]#bearer-capability
tbl-name key dest-interface if-name
or
node (ctx-cs)[ switch ]# bearer-capability
tbl-name key dest-table tbl-name
2
Example: Bearer capability routing table
SN(ctx-cs)[switch]#bearer-capability BC audio71 dest-interface local-breakout
SN(ctx-cs)[switch]#bearer-capability BC ud dest-interface ISoIP-Access
SN(ctx-cs)[switch]#bearer-capability BC video dest-interface ISoIP-Access
SN(ctx-cs)[switch]#bearer-capability BC default dest-interface VoIPCarrierA

Create a time of day routing table

The time table is used to route calls based upon the current system time during one day, i.e. an 24hr. period
from midnight to midnight. Times are matched within the ranges defined in the time routing table.
This procedure describes how to create a time of day routing table
Mode: Context CS
Step
1 node (ctx-cs)[ switch ]#time tbl-name key dest-
interface if-name
or
node (ctx-cs)[ switch ]#time tbl-name key dest-
table tbl-name
318
Command
Command
SmartWare Software Configuration Guide
Purpose
Create a bearer-capability routing table by adding
the first line.
Repeat step 1 to add lines for multiple table
entries.
Purpose
Create a time routing table by adding the first line.
Session router configuration task list