Debug Isoip Data; Debug Voice Over Ip Data - Patton electronics SmartNode Series Software Configuration Manual

31 • VoIP debugging
command enables the session-control debug monitor to show transposed data between ISDN and VoIP proto-
cols. Additionally a VoIP session could be closed manually by a command.
This procedure describes how to obtain information about session-control.
Mode: Administrator execution
Step
1 node #show session-control subsystems
[ detail-level ]
2 node#show session-control sessions
[ detail-level ]
3 node #debug session-control [ detail-level ]
node #session-control close [ session-id ]
4

Debug ISoIP data

You can use the ISoIP debug commands if there are problems with setting up and establishing calls over ISoIP.
The show command displays information about ISoIP connections and sessions. An ISoIP connection con-
tains one ore more ISoIP sessions. Generally an ISoIP connection is set up and is then used for several ISoIP
sessions. If no session establishes for about two minutes the ISoIP connection is closed.
The debug command enables the H.323 debug monitor to show specific information for establishing and clos-
ing ISoIP connections.
This procedure describes how to obtain information about ISoIP data
Mode: Administrator execution
Step
1 node #show gateway isoip connections
[ detail-level ]
2 node #show gateway isoip sessions
[ detail-level ]
3 node #debug gateway isoip [ detail-level ]

Debug Voice over IP data

There are several debug monitors that can help identify problems in VoIP connections. The most common
VoIP problems are: voice quality problems (dropouts), fax transmission errors, no establishing of voice connec-
tion, no or wrong tone playback.
An overview of all available VoIP debug monitors is given below. Some more specific examples for debugging
cases follow after that.
402
Command
Command
SmartWare Software Configuration Guide
Purpose
Show registered subsystems
Show open VoIP data sessions
Enable the session-control debug monitor to show
exchanged data between ISDN and VoIP proto-
cols.
Close an established VoIP session manually, enter
'all' to close all sessions.
Purpose
Show the actual status of ISoIP connections.
Show the actual status of ISoIP sessions
Enable the ISoIP debug monitor to get information
about ISoIP connections.
Debugging task list