Patton electronics SmartNode Series Software Configuration Manual page 304

24 • CS interface configuration
Note
If you use this feature on a H.323 interface you have also to enable Q.931
tunneling as described in more detail in chapter 20,
on page 235.
Note
If no port address is specified for an interface, all calls with no port address
are routed to that interface. If a call has a port address which is not specified
on a interface, the call will be rejected.
Figure 58. VoIP interfaces with identical port-ID determine a virtual tunnel
This procedure describes how to configure the port identifier for a H.323 or ISoIP interface
Mode: Interface below Context CS
Step
1 node ( if-type )[ if-name ]#portaddress address
Example: Specifying a port address
The following example shows how to set the port address to value 5 for a H.323 interface and enable Q.931
tunneling to use this feature in an H.323 network.
SN>enable
SN#configure
SN(cfg)#context cs
302
Command
SmartWare Software Configuration Guide
"DHCP configuration"
Purpose
Specify the port address for a H.323 or ISoIP
interface.
CS interface configuration task list