SmartWare Software Configuration Guide
Example: Configuring an interface as a point-to-point link
The following example shows how to define interface lan as point-to-point link. Use the following commands
in configuration mode.
SN(cfg)#context ip router
SN(ctx-ip)[router]#interface lan
SN(if-ip)[lan]#point-to-point
Displaying IP interface information
SmartWare contains the show ip interface command, which displays IP information for all interfaces. The
command is available in operator execution mode or in any of the administrator execution modes.
Mode: Operator execution or any administrator execution
Step
Command
node >show ip interface
1
example: displaying ip interface information
The following example shows how to display IP information for all interfaces using the show ip interface com-
mand from operator execution mode.
SN>show ip interface
------------------------------------------------------------
Context:
Name:
IP Address:
MTU:
ICMP router-discovery:
ICMP redirect:
State:
Binding:
------------------------------------------------------------
Context:
Name:
IP Address:
MTU:
ICMP router-discovery:
ICMP redirect:
State:
Binding:
Testing connections with the ping command
As an aid to diagnosing basic network connectivity, many network protocols support an echo protocol. The
protocol involves sending a special datagram to the destination host, then waiting for a reply datagram from
that host. Results from this echo protocol can help in evaluating the path-to-host reliability, delays over the
path, and whether the host can be accessed or is functioning.
Software IP interface configuration task list
Displays IP information for all interfaces
router
lan
172.16.40.77 255.255.0.0
1500
enabled
send only
OPENED
ethernet 0 0 0/ethernet/ip
router
wan
172.17.100.210 255.255.255.0
1500
enabled
send only
CLOSED
ethernet 0 0 1/ethernet/ip
10 • IP interface configuration
Purpose
115
Need help?
Do you have a question about the SmartNode Series and is the answer not in the manual?