Patton electronics SmartNode Series Software Configuration Manual page 374

29 • Gateway configuration
Mode: Gateway ISoIP or gateway H.323
Step
1 node (gw- type )[ gw-name ]#bind interface if-
name
2 node (gw- type )[ gw-name ]#show gateway
h323 config
3 node (gw- type )[ gw-name ]#no shutdown
Example: Enabling an H.323 gateway configuration
The following example shows how to bind to an IP interface, display and then enable an already defined
H.323 gateway.
SN(cfg)#gateway h323 h323
SN(gw-h323)[h323]#bind interface eth00
SN(gw-h323)[h323]#show gateway h323 config
CURRENT H.323 GATEWAY CONFIGURATION
State : enabled
RAS : disabled
Call-signaling port : 1720
Q.931-tunneling : disabled
Faststart : enabled
Codecs :
G.711 A-law, rxlen:10, txlen:10
G.711 U-law, rxlen:20, txlen:10
G.723, rxlen:10, txlen:10
G.729, rxlen:10, txlen:10
H.323-ID :
E.164 alias :
Binding: ip-context 'router', interface 'eth00' ip-address '172.16.40.123'
SN(gw-h323)[h323]#no shutdown
372
Command
SmartWare Software Configuration Guide
Purpose
Only H.323: Bind H.323 gateway to IP interface
Only H.323: Show H.323 gateway configuration
Enable the H.323 or ISoIP gateway
Gateway configuration task list