Display Clock Information; Display Time Since Last Restart - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Configure
Step
1 node (cfg)#clock set yyyy-mm-ddThh:mm:ss
Note
SmartWare includes an integrated SNTP client, which allows synchroniza-
tion of time-of-day and date to a reference time server. Refer to chapter 19,
"SNTP client configuration"
Example: Setting time and date
The following example shows the commands used to set the system clock of your device to August 6, 2001 at
16:55:57, if you start from the operator execution mode.
SN(cfg)#clock set 2001-08-06T16:55:57

Display clock information

This procedure describes how to display the current date and time
Mode: Both in operator and administrator execution
Step Command
1 node >show clock
Example: Display clock information
The following example shows the commands used to display the time and date settings of your device in local
time, if you start from the operator execution mode.
SN>show clock
2001-08-06T16:55:57

Display time since last restart

This procedure describes how to display the time since last restart
Mode: Operator execution
Step Command
node >show uptime
1
Example:
The following example shows how to display the uptime of your device, if you start from the configuration mode.
SN>show uptime
The system is up for 1 days, 23 hours, 44 minutes, 18 seconds
Basic system management configuration task list
Command
on page 223 for more details.
Display the local time.
Display the time since last restart.
8 • Basic system management
Purpose
Sets the system clock to yyyy-mm-ddThh:mm:ss
Purpose
Purpose
95