Ic_Voice; Profile_Acl; Profile_Service-Policy; Source - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
[no] bypass-mode
clock-source {internal | (<slot> <port> ) }
[no] synchronize-to-isdn-time
[no] local-inband-tones

ic_voice

ic voice <slot>
pcm {(law-select {aLaw | uLaw } ) }
exit
exit
profile_acl
[no] profile acl <profile_name>
{permit|deny} {({ip|ah|esp|gre} {any | (host <src_ip> ) | (<src_ip> <src_wildcard> )
} {any | (host <dst_ip> ) | (<dst_ip> <dst_wildcard> ) } ) | ({tcp|udp|sctp}
{any | (host <src_ip> ) | (<src_ip> <src_wildcard> ) } [eq <src_port> lt
<src_port> gt <src_port> range <src_port_from> <src_port_to> ] {any | (host
<dst_ip> ) | (<dst_ip> <dst_wildcard> ) } [eq <dst_port> lt <dst_port> gt
<dst_port> range <dst_port_from> <dst_port_to> ] ) | (icmp {any | (host
<src_ip> ) | (<src_ip> <src_wildcard> ) } {any | (host <dst_ip> ) | (<dst_ip>
<dst_wildcard> ) } [name {administratively-prohibited|alternate-address|con-
version-error|dod-host-prohibited|dod-net-prohibited|echo|echo-reply|general-
parameter-problem|host-isolated|host-precedence-unreachable|host-redi-
rect|host-tos-redirect|host-tos-unreachable|host-unknown|host-unreach-
able|information-reply|information-request|mask-reply|mask-request|mobile-
redirect|net-redirect|net-tos-redirect|net-tos-unreachable|net-unreach-
able|network-unknown|no-room-for-option|option-missing|packet-too-big|parame-
ter-problem|port-unreachable|precedence-unreachable|protocol-
unreachable|reassembly-timeout|redirect|router-advertisement|router-solicita-
tion|source-quench|source-route-failed|time-exceeded|timestamp-reply|times-
tamp-request|traceroute|ttl-exceeded|unreachable} type <type> type <type> code
<code> ] ) } [[tos {max-reliability|max-throughput|min-delay|min-monetary-
cost|normal} ] [precedence {{critical|flash|flash-override|immediate|inter-
net|network|priority|routine} | <precedence> } ] dscp <dscp> [mask
{1|3|7|15|31} ] ] [cos <cos> cos-rtp <cos_rtp> <cos_rtcp> ] [ipsec-pol-
icy<ipsec_policy>]
exit
profile_service-policy
[no] profile service-policy <arbiter-name>
mode {shaper | burst-shaper | wfq | burst-wfq }
[no] rate-limit <value> [header-length <option-value> ]
[no] queue-limit <value>
[no] set ip dscp <value>
[no] set ip precedence <value>
[no] set ip tos <value>
[no] set layer2 cos <value>
[no] debug queue statistics [<value> ]

source

[no] source {(class <source-name> ) | (policy <source-name> ) }
rate {<value> | remaining }
share <value>
[no] random-detect [<value> ]
SmartWare 2.20 command summary
B • Configuration mode overview
423