Ending A Telnet Or Console Port Session - Patton electronics SmartNode Series Software Configuration Manual

4 • Accessing the CLI

Ending a Telnet or console port session

To end a Telnet or console port session you use the logout command in the operator or administration execution
mode. To confirm the logout command you have to enter "yes" on the dialog line as show in the example below.
Mode: Operator execution
Step Command
1 node> logout
Example: End a Telnet or console port session
The following example shows how to terminate a session from the administrator execution configuration
mode.
SN>logout
Press 'yes' to logout, 'no' to cancel :
After confirming the dialog with "yes" the Telnet session to the SmartNode is terminated and the Telnet appli-
cation window on your host closes.
Note
Using the command exit in the operator execution mode also terminates a
Telnet or console port session, but without any confirmation dialog.
52
Purpose
Terminates session after a confirmation by user.
SmartWare Software Configuration Guide
Accessing the SmartWare CLI task list