Show Call-Progress-Tone And Tone-Set Profiles - Patton electronics SmartNode Series Software Configuration Manual

26 • Tone configuration
Mode: Context cs
Step
1 node (ctx-cs)[ switch ]#use tone-set-profile
name
2 node (ctx-cs)[ switch ]#interface if-type if-name Enter CS interface configuration mode.
node ( if-type )[ if-name ]#use tone-set-profile
3
name
4 node ( if-type )[ if-name ]#system
5 node (sys)#local-inband-tones
Example: Assign tone-set profiles to CS context and CS interface and enable local in-band tone generation
The example shows how to use the SWISS tone-set for the CS context, and use the USA tone-set for an indi-
vidual interface.
SN(cfg)#context cs
SN(ctx-cs)[switch]#use tone-set-profile SWISS
SN(ctx-cs)[switch]#interface pstn bri0
SN(if-pstn)[bri0@switch]#use tone-set-profile USA
SN(if-pstn)[bri0@switch]#system
SN(sys)#local-inband-tones
Show call-progress-tone and tone-set profiles
Use the show commands to display the call-progress-tone profiles as well as the tone-set profiles.
This procedure describes how to show call-progress-tone profiles
Mode: administrator exec
Step
1 node #show profile call-progress-tone
[ name ]
336
SmartWare Software Configuration Guide
Command
Command
Purpose
Assign the tone-set profile to the CS context.
Assign an other tone-set profile to a CS interface.
Enter system configuration mode
Enable generation of local in-band tones
Purpose
Display all call-progress-tone profiles or a specific
with name name
Tone configuration task list