Patton electronics SmartNode Series Software Configuration Manual page 18

About this guide
• Chapter 3, "Command line interface (CLI)"
that allow you to navigate the CLI and edit commands effectively.
• Chapter 4, "Accessing the CLI"
the command line interface (CLI), to obtain help, to change operator mode and to terminate a session.
• Chapter 5, "Establishing basic IP connectivity"
nections to and from your SmartNode using IP interfaces and Ethernet ports.
• Chapter 6, "System image handling"
driver software.
• Chapter 7, "Configuration file handling"
files from and to a SmartNode 1000, 2000, or 4000 Series devices.
• Chapter 8, "Basic system management"
tion to the operator or administrator, and their configuration.
• Chapter 9, "IP context overview"
together with its related components.
• Chapter 10, "IP interface configuration"
and describes the tasks involved in configuring them.
• Chapter 11, "NAT/NAPT configuration"
Port Translation and describes the tasks involved in configuring it.
• Chapter 12, "Ethernet port configuration"
describes the tasks involved in configuring Ethernet ports through the Patton SmartWare.
• Chapter 13, "Link scheduler configuration"
Ware, Quality of Service (QoS) features.
• Chapter 14, "Serial port configuration"
the tasks involved in configuring the serial port through the Patton SmartWare.
• Chapter 15, "Basic IP routing configuration"
the tasks involved in configuring static IP routing in SmartWare.
• Chapter 16, "RIP configuration"
(RIP) and describes the tasks involved in configuring RIP features within SmartWare.
• Chapter 17, "Access control list configuration"
and describes the tasks involved in configuring them through the Patton SmartWare.
• Chapter 18, "SNMP Configuration"
Management Protocol (SNMP) and describes the tasks used to configure those of its features supported by
the Patton SmartWare.
• Chapter 19, "SNTP client configuration"
Protocol (SNTP) client.
• Chapter 20, "DHCP configuration"
Control Protocol (DHCP) and describes the tasks involved in configuring them.
16
on page 35 gives an overview of the CLI and the basic features
on page 43 describes the procedures for entering SmartWare commands via
on page 53 explains how to establish network-based con-
on page 61 describes how to load and maintain system images and
on page 77 describes how to upload and download configuration
on page 91 describes parameters that report basic system informa-
on page 101 outlines the SmartWare Internet protocol (IP) context ,
on page 109 provides a general overview of SmartNode interfaces
on page 119 provides a general overview of Network Address
on page 127 provides an overview of Ethernet ports and
on page 137 describes how to use and configure the Smart-
on page 159 provides an overview of the serial port and describes
on page 177 provides an overview of IP routing and describes
on page 183 provides an overview of the Routing Information Protocol
on page 193 provides an overview of IP Access Control Lists
on page 207 provides overview information about Simple Network
on page 223 describes how to configure Simple Network Time
on page 235 provides an overview of the Dynamic Host Configuration
SmartWare Software Configuration Guide