Displaying Ip Route Information - Patton electronics SmartNode Series Software Configuration Manual

15 • Basic IP routing configuration
Mode: Administrator execution
Step
1 node (cfg)#context ip router
2 node (ctx-ip)[router]#no route network mask { address | interface } Deletes a static route
Example: Deleting a static IP route
In the following example, the route for packets to network 20.0.0.0/24, which are routed to device with IP
address 172.17.100.2, shall be deleted.
SN>enable
SN#configure
SN(cfg)#context ip router
SN(ctx-ip)[router]#no route 20.0.0.0 255.255.255.0 172.17.100.2

Displaying IP route information

This procedure describes how to display static IP routes
Mode: Operator or administrator execution
Step Command
1 node >show ip route
This command displays the destination address, next-hop interface, protocol (local, static, rip, or icmp), met-
ric, flags (U up, H host, G Gateway, L local, D default), and amount of use for each route in the routing table.
If there are multiple routes to the same destination, the preferred route is indicated by an asterisk (*).
Example: Displaying IP route
In the following example, IP route information is displayed.
SN>show ip route
Routes of IP context 'router':
Status codes: * valid, U up, H host, G Gateway, L local, D default
Destination
---------------------------------------------------------------------
* 127.0.0.1/32
* 172.16.40.77/32
* 172.17.100.210/32
* 172.17.100.0/24
* 20.0.0.0/24
* 172.16.0.0/16
180
Command
Displays IP route information
Nexthop Protocol
local
local
local
wan local
172.17.100.2 static
lan local
SmartWare Software Configuration Guide
Enters the IP router context
Purpose
Metric Flags Used
0 LHG
0 LHG
0 LHG
1 UL
0 U
1 UL
Basic IP routing configuration task list
Purpose
n/a
n/a
n/a
0
0
6