Configure Direct Call Signaling On Voip Interfaces - Patton electronics SmartNode Series Software Configuration Manual

24 • CS interface configuration
Collected overlap dialed digits are sent providing that they comply with one or a combination of three criteria:
elapse a specific timeout, receive a specific character or receive a specified number of dialed digits.
This procedure describes how to configure the digit collection
Mode: Interface below Context CS
Step
1 node ( if-type )[ if-name ]#digit-collection timeout seconds
2 node ( if-type ) [ if-name ]#digit-collection terminating-char
character
3 node ( if-type ) [ if-name ]#digit-collection nr-length length
Example: Configure
digit collection
In the following example the SmartNode sends the bloc of numbers either when the asterisk character '*' is
received or after 4 seconds have elapsed since the last dialed digit.
SN(if-h323)[h323_0]#digit-collection timeout 4
SN(if-h323)[h323_0]#digit-collection terminating-char *
Configure direct call signaling on VoIP interfaces
Call signaling is a basic requirement needed to set up and close down a call between two endpoints. A call can
be established between two VoIP interfaces, that is either between two ISoIP or between two H.323 interfaces.
So that a call can be set up the VoIP interface needs the IP address of its remote device. In direct call signaling
this is configured for each VoIP interface directly. In an H.323 network it is possible to obtain the remote IP
300
Figure 57. Digit collection in a H.323/ISoIP interface
Command
SmartWare Software Configuration Guide
Purpose
Specify the timeout to wait for the
first dialed or between two dialed
digits before all previous digits
are sent.
Specify a character that indicates
the end of the dialed digits # or *
Specify a number of digits to col-
lect
CS interface configuration task list