Dhcp-Client Configuration Tasks; Enable Dhcp-Client On An Ip Interface - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
vides other clients on the LAN side with IP addresses and other configuration information. DHCP-server and
DHCP-client are illustrated in
DHCP-client configuration tasks
To configure the SmartNode as DHCP-client perform the steps mentioned below.
•

Enable DHCP-client on an IP interface

• Release or renew a DHCP lease manually (advanced) (see
• Get debug output from DHCP-client (see
• Configure DHCP agent

Enable DHCP-client on an IP interface

On every created IP interface a DHCP-client could be enabled. If enabled, the SmartNode gets the IP address
for this interface from a DHCP-server. Additionally other configuration information is received for this IP

DHCP-client configuration tasks

figure 49.
Figure 49. DHCP-client and DHCP-server on the SmartNode
page
page 238)
239)
20 • DHCP configuration
237