Situation - Patton electronics SmartNode Series Software Configuration Manual

23 • CS context overview
00:01:39 SR
00:01:39 SR
00:01:39 SR
00:01:39 SR
00:01:39 SR
00:01:39 SR
00:01:39 SR
00:01:39 SR
SN(ctx-cs)[switch]#
Example: Configure SmartNode in an enterprise network

Situation

Figure 54 on page 287 shows an enterprise network with a SmartNode 2300 series with a BRI interface card in
slot 2. A PBX, a LAN, the PSTN and the company network are connected. The VoIP protocol used is H.323.
There is no gatekeeper, therefore 'direct call signaling' is used. The voice codec used is G.723, therefore DTMF
relay is enabled. Because no special dial tones have to be specified, the default tone-set profile is used.
Call routing is specified as follows:
• Calls from office C with number 1xx to office A with a fallback to PSTN
• Calls from office C with number 2xx to office B with a fallback to PSTN
• All other calls from office C to PSTN
• Calls from office A or B with number 5xx to office C
• All other calls from office A or B to the PSTN (local breakout)
286
> Loading and linking complete...
> Following voice interfaces have been loaded:
> callapp
> H323_IF
> ISDN
> Following routing tables have been loaded:
> Following functions have been loaded:
> Following number replacement tables have been loaded:
SmartWare Software Configuration Guide
CS context configuration task list