Execute A Program Loaded Into Memory; Manage Program Images In Flash Memory; Display Images Stored In Flash Memory - Patton electronics SmartNode Series Software Configuration Manual

B • Configuration mode overview

Execute a program loaded into memory

Step 1 go [-w timeout ] [-i] [-s script-name ]
[ entry ]

Manage program images in Flash memory

The following commands manage program images that are stored in the Flash memory.

Display images stored in Flash memory

Step 1 fis list [-l]
RedBoot> fis list
Id Address Length
---------------------------------------------------------------------
1 0x60030000 1693438
RedBoot> fis list -l
Id Address Length
Entry Load Addr
---------------------------------------------------------------------
1 0x60030000 1693438
0x01800100 0x01800100
434
Command
Command
State
valid
State
valid
SmartWare Software Configuration Guide
Purpose
Executes a program that has formerly been loaded
to memory.
The command will check whether a SmartWare
application has been loaded to the specified
address. It will abort with an error message if not.
-w: Timeout before program is started. You can
abort the countdown by pressing CTRL-C.
-i: Start program with caches disabled.
-s: Name of startup-config the program shall exe-
cute.
entry: Address of program in memory.
Purpose
Displays images stored in Flash memory.
-l: Long format, displays additional information
Description
SmartWare R2.10 BUILD28015
Description
Version
SmartWare R2.10 BUILD28015
V2.10
RedBoot Bootloader command set