Closing An Ethernet Port - Patton electronics SmartNode Series Software Configuration Manual

12 • Ethernet port configuration
Mode: Configure
Step
1 node (cfg)#port ethernet slot port
2 node (prt-eth)[ slot/port ]#cos tx-map service class value as layer 2 class of
service value
Example: Adding a transmit mapping table entry
The following example shows how to add a transmit mapping table entry, which converts a service class value
of 4 into a layer 2 class of service value of 2 for the Ethernet port on slot 0 and port 0 of a SmartNode 1000,
2000, or 4000 series device.
SN(cfg)#port ethernet 0 0
SN(prt-eth)[0/0]#cos tx-map 4 as 2

Closing an Ethernet port

An Ethernet port can be closed with the shutdown command. This command also disables and closes the IP
interface that is bound to that port. All static routing entries that are using this interface change their state to
'invalid' and all dynamic routing entries will be removed from the route table manager.
This command can be used as soon as an encapsulation type is defined and the port was bound successful to an
IP interface.
This procedure describes how to disable the Ethernet port on slot and port
Mode: Configure
Step Command
node (cfg)#port ethernet slot port
1
2 node (prt-eth)[ slot/port ]#shutdown Disables Ethernet port on slot and port
The no prefix causes the port to be opened together with the interface to which the port is bound.
Example: Disabling an Ethernet port
The following example shows how the Ethernet port on slot 0 and port 0 of a SmartNode 1000, 2000, or 4000
series device.
134
Command
Enters Ethernet port configuration mode for the interface on
slot and port
SmartWare Software Configuration Guide
Enters Ethernet
port configura-
tion mode for
the interface on
slot and port
Adds a transmit
mapping table
entry, which
converts a ser-
vice class value
into a layer 2
class of service
Purpose
Ethernet port configuration task list
Purpose