Configuration File Handling Task List - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
uration at any time during the operation of a SmartNode configuration. The getting started guide included
with your SmartNode device describes the restoration procedure for restoring the default settings.
Configuration file handling task list
This section describes how to create, load, and maintain configuration files. Configuration files contain a set of
user-configured commands that customize the functionality of your SmartNode device to suit your own oper-
ating requirements.
The tasks in this chapter assume that you have at least a minimal configuration running on your system. You
can create a basic configuration file by using the configure command; see section
figuration at the CLI" on page 91 for details.
To display, copy, delete, and download or upload configuration files, perform the tasks described in the follow-
ing sections:
• Copying configurations within the local memory (see
• Replacing the startup configuration with a configuration from the Flash memory (see
• Copying configurations to and from a remote storing location (see
• Replacing the startup configuration with a configuration downloaded from the TFTP server (see
• Displaying configuration file information (see
• Modifying the running configuration at the CLI (see
• Modifying the running configuration offline (see
• Deleting a specified configuration (see

Configuration file handling task list

Avoid downloading any configuration file if you do not com-
pletely understand what you have to do! If a configuration file
download fails or succeeds only partially your SmartNode device
cannot start up without a support intervention at the factory.
page
page 93)
page 86)
page 89)
91)
page 91)
page 92)
7 • Configuration file handling
"Modifying the running con-
page 87)
page 90)
85