SmartWare Software Configuration Guide
The following example shows how to attach the service policy profile Voice_Prio to the IP interface wan that is
defined within the IP context for outgoing traffic.
SN>enable
SN#configure
SN(cfg)#context ip router
SN(ctx-ip)[router]#interface wan
SN(if-ip)[wan]#use profile service-policy Voice_Prio out
Displaying link arbitration status
The show service-policy command displays link arbitration status. This command supports the optional argu-
ment interface that select a certain IP interface. This command is available in the operator mode.
This procedure describes displaying the link arbitration status on all interfaces or a certain interface.
Mode: Operator execution
Step
1
node >show service-policy {interface name } Displays the link arbitration status
Example: Displaying link arbitration status
The following example shows how to display link arbitration status information.
SN>show service-policy
available queue statistics
--------------------------
default
- packets in queue: 10
Displaying link scheduling profile information
The show profile service-policy command displays link scheduling profile information of an existing service-
policy profile. This command is only available in the administrator mode.
This procedure describes displaying link scheduling profile information of an existing service-policy profile
Mode: Administrator execution
Step
1
node #show profile service-policy name Displays link scheduling profile information of the
Example: Displaying link scheduling profile information
The following example shows how to display link scheduling profile information of an existing service-policy
profile VoIP_Layer2_CoS.
SN#show profile service-policy VoIP_Layer2_CoS
VoIP_Layer2_CoS
default (mark layer 2 cos -1)
Link scheduler configuration task list
Command
Command
13 • Link scheduler configuration
Purpose
service-policy profile name
Purpose
157
Need help?
Do you have a question about the SmartNode Series and is the answer not in the manual?