Modify Configuration; Re-Initialize Configuration To Default Values; Read Data From Eeprom; Enable/Disable Cache - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Modify configuration
Step 1 fconfig
Re-initialize configuration to default values
Step 1 fconfig -i

Read data from EEPROM

Step 1 eeprom read -e eeprom_addr
-b mem_base -l length [-i device ]

Enable/Disable cache

Step 1 cache [on | off]
RedBoot Bootloader command set
Command
Command
Command
Command
B • Configuration mode overview
Purpose
Modifies configuration.
Each option is printed to the console and you are
asked to modify it. Press enter to leave the value
unchanged, or use the backspace key to delete the
current value and specify the new value.
Note: It is not possible to retain to boot script. It has
to be retyped each time you run this command.
Entering an empty line ends the boot script.
Purpose
The command asks for confirmation, before it resets
all values to their defaults.
Purpose
Reads data from EEPROM and stores it in RAM.
-e: EEPROM address to read.
-b: Memory address to write data to.
-l: Number of bytes to read
-i: Device ID (default: 100 = Mainboard)
Purpose
Enables/Disables cache memory.
If called without arguments, shows current cache
state.
437