Configure Vlan Add Elrp-Poll Ports - Extreme Networks ExtremeWare Command Reference Manual

configure vlan add elrp-poll ports

configure vlan <vlan name> add elrp-poll ports [<portlist> | all]
Description
Configures the ports of a VLAN where ELRP packet transmission is requested by ESRP.
Syntax Description
vlan name
portlist
all
Default
All ports of an ESRP-enabled VLAN have ELRP transmission enabled.
Usage Guidelines
This command allows you to configure the ports in your network that might experience loops, such as
ports that connect to master, slave, or ESRP-aware switches, to receive ELRP packets. You do not need
to send ELRP packets to host ports.
Example
The following command enables ELRP packet transmission for ports 3-5 on VLAN esrp1:
configure vlan esrp1 add elrp-poll ports 3-5
History
This command was first available in ExtremeWare 6.2.2b134.
This command was not supported in ExtremeWare 7.0.
This command is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies an ESRP-enabled VLAN name.
Specifies list of ports or slots and ports. May be in the form 1, 2, 3-5, 2:*, 2:5,
2:6-2:8.
Specifies all ports in the VLAN.
configure vlan add elrp-poll ports
1067