Configure Ospf Direct-Filter - Extreme Networks ExtremeWare Command Reference Manual

configure ospf direct-filter

configure ospf direct-filter [<access profile> | none]
Description
Configures a route filter for direct routes.
Syntax Description
access profile
none
Default
N/A.
Usage Guidelines
If none is specified, all direct routes are exported if ospf export direct is enabled.
In versions of ExtremeWare before release 6.0, direct routes corresponding to the interfaces on which
RIP was enabled were exported into OSPF as part of RIP routes, using the command enable ospf export
rip. Using ExtremeWare 6.0 and above, you must configure ExtremeWare to export these direct routes to
OSPF. You can use an access profile to filter unnecessary direct routes.
For switches configured to support direct route re-distribution into OSPF, an access profile can be used
to limit the routes that are advertised into OSPF for the switch as a whole.
Example
The following command configures a route filter for direct routes based on the access profile nosales:
configure ospf direct-filter nosales
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies an access profile.
Specifies not to apply a direct filter.
configure ospf direct-filter
1305