Configure Isis Vlan Hello-Multiplier - Extreme Networks ExtremeWare Command Reference Manual

configure isis vlan hello-multiplier

configure isis [vlan <vlan name> | all] [level-1| level-2 | level-1-2]
hello-multiplier <number(3-1000)>
Description
Configures the number of IS-IS Hello packets an IS-IS neighbor at a particular level on this routing
interface must miss before the it declares that the adjacency with this system is down.
Syntax Description
vlan name
all
level-1
level-2
level-1-2
hello-multiplier
Default
The default hello multiplier number is 3.
Usage Guidelines
If is specified, the hello multiplier is applied to all the routing interfaces in the system. The
all
advertised hold time in the IS-IS hellos is the
The
hello multiplier
The
level-1
Example
The following command configures the hello multiplier on level 1 of all VLANs to be 100.
configure isis vlan all level-1 hello-multiplier 100
History
This command was first available in ExtremeWare v6.1.8 IS-IS tech release and subsequently
incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies the name of a VLAN.
Specifies all VLANs.
Specifies IS-IS level 1.
Specifies IS-IS level 2.
Specifies IS-IS level 1 and level 2.
Specifies the hello multiplier.
range is 3 to 1000, and the default is 3.
, , and
level-2 level-1-2
hello multiplier
options specify the levels to which the timers are applied.
configure isis vlan hello-multiplier
times the
hello interval
.
1279