Disable Rip Exportstatic - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

IGP Commands

disable rip exportstatic

Disables the redistribution of static routes.

Syntax Description

This command has no arguments or variables.

Usage Guidelines

Static routes are manually entered into the routing table. Static routes are used to reach networks not

advertised by routers. You can configure 64 static unicast routes. Static routes can also be used for

security reasons, to control which routes you want advertised by the router. You can decide if you want

all static routes to be advertised. Static routes are never aged out of the routing table.

A static route must be associated with a valid IP subnet. An IP subnet is associated with a single VLAN

by its IP address and subnet mask. If the VLAN is subsequently deleted, the static route entries using

that subnet must be deleted manually.

The following command disables the redistribution of static routes:

disable rip exportstatic

This command was removed in ExtremeWare 6.0.

Platform Availability

This command is available on all platforms.

ExtremeWare Software 7.3.0 Command Reference Guide

Extremeware 7.3.0