Extreme Networks ExtremeWare Command Reference Manual page 1039

The following command displays the state of slot 3, ports 1 through 3 on an STPD named s0 on a
modular switch:
show stpd S0 ports 3:1-3:3
The results for this command are as follows:
* Alpine3804:4 # show stpd s0 ports 3:1-3:3
Port Mode
3:1 802.1D FORWARDING 100
3:2 802.1D FORWARDING 100
3:3 802.1D FORWARDING 100
Total Ports: 14
------------------------- Flags: ----------------------------
1:
2:
3: (Port role)
4: (Config type)
5: (Oper. type)
6:
7: (partner mode) d = 802.1d, w = 802.1w
8:
History
This command was first available in ExtremeWare 2.0.
Support for modular switches was introduced in ExtremeWare 4.0.
Support for the
Support for the
Support for displaying RSTP data was introduced in ExtremeWare 7.1.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
State Cost Flags Priority Port ID Designated Bridge
e------- 16
e------- 16
e------- 16
e=Enable, d=Disable
L = Loopback port
R=Root, D=Designated, A=Alternate, B=Backup
b=broadcast, p=point-to-point, e=edge, a=auto
b=broadcast, p=point-to-point, e=edge
p=proposing, a=agree
i = edgeport inconsistency
keyword was introduced in ExtremeWare 4.0.
all
keyword was introduced in ExtremeWare 6.2 and replaced the
detail
16641 00:00:00:00:00:00:00:00
16642 00:00:00:00:00:00:00:00
16643 00:00:00:00:00:00:00:00
show stpd ports
keyword.
all
1039