Extreme Networks ExtremeWare Command Reference Manual page 1241

The following example shows global output for the
show ipconfig
Following is sample output from this command:
Router Interface[1] on VLAN test is enable and up.
UDP Forwarding profile: none.
inet 11.3.3.4 netmask 0xffffff00 broadcast 11.3.3.255
Secondary:
Multicast ttl 1 metric 1 mtu 1500
Locally registered multicast address (Last Querier=11.3.3.4):
224.0.0.1
Flags:
AddrMaskRly
IgnoreBcast
History
This command was first available in ExtremeWare 2.0.
This command was modified in an ExtremeWare IP Technology Services Release based on ExtremeWare
v6.1.8b12 to support MPLS modules.
The output for this command was changed to accommodate the multinetting feature by including
secondary IP addresses. This modified command was made available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
inet 11.4.3.4 netmask 0xffffff00 broadcast 11.4.3.255
NO BOOTP Host
ESRP NO Fwd Bcast
NO IP Fwding
ISIS NO
MPLS NO NAT-Inside
PIM NO
SendPortUn YES Send Redir YES
SLB-Cli NO
VRRP NO
show ipconfig
NO DirBcstHwFwd
NO
NO IPmc Fwd
ISQ NO
NO NAT-Outside
RIP NO
SendTimxceed YES
SLB-Srv NO SubVLAN Prxy YES
command:
NO DVMRP
IGMP YES IGMP Ver
NO IRDP Advert
LDP NO LPM-routing
NO OSPF
RSVP NO SendParam YES
SendUnreach YES
TimeStampRly
show ipconfig
NO
V2
NO
NO
NO
NO
1241