Configure Vlan Esrp Esrp-Premaster-Timeout - Extreme Networks ExtremeWare Command Reference Manual

configure vlan esrp esrp-premaster-timeout

configure vlan <vlan name> esrp esrp-premaster-timeout <premaster-timer
(0-512, 0 restores dflt)>
Description
Configures the ESRP pre-master timeout value.
Syntax Description
vlan name
premaster-timer
Default
The default timeout is 6 seconds (three times the hello timer).
Usage Guidelines
The
premaster-timer
see the
premaster-timer
CAUTION
Configure the pre-master state timeout only with guidance from Extreme Networks personnel.
Misconfiguration can severely degrade the performance of ESRP and your switch.
Example
The following command configures the pre-master timeout to 10 seconds for the VLAN
configure vlan esrp-1 esrp esrp-premaster-timeout 10
History
This command was first available in ExtremeWare 7.1.0, and replaced the
esrp-neutral-timeout
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies a VLAN name.
Specifies the maximum length of time, in seconds, that the transitioning
master VLAN remains in the pre-master state. The range is 0 to 512.
range is 0 - 512. If you set the
settings, use the
show esrp vlan
command.
configure vlan esrp esrp-premaster-timeout
to 0, ESRP uses the default. To
premaster-timer
command.
configure vlan esrp
:
esrp-1
1095