Configure Bootprelay Add - Extreme Networks ExtremeWare Command Reference Manual

IP Unicast Commands

configure bootprelay add

configure bootprelay add <ip address>
Description
Configures the addresses to which BOOTP requests should be directed.
Syntax Description
ip address
Default
N/A.
Usage Guidelines
After IP unicast routing has been configured, you can configure the switch to forward Dynamic Host
Configuration Protocol (DHCP) or BOOTP requests coming from clients on subnets being serviced by
the switch and going to hosts on different subnets. To configure the relay function, follow these steps:
1 Configure VLANs and IP unicast routing.
2 Enable the DHCP or BOOTP relay function, using the following command:
enable bootprelay
3 Configure the addresses to which DHCP or BOOTP requests should be directed, using the following
command:
configure bootprelay add <ip address>
Example
The following command configures BOOTP requests to be directed to 123.45.67.8:
configure bootprelay add 123.45.67.8
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms
1146
Specifies an IP address.
ExtremeWare Software 7.3.0 Command Reference Guide