Configure Isis Vlan - Extreme Networks ExtremeWare Command Reference Manual

IGP Commands

configure isis vlan

configure isis [vlan <vlan name> | all] [level-1| level-2 | level-1-2]
[passive | non-passive]
Description
Configures the different IS-IS levels on a routing interface as passive or non-passive.
Syntax Description
vlan name
all
level-1
level-2
level-1-2
passive
non-passive
Default
By default, all the routing interfaces are non-passive.
Usage Guidelines
If is specified, all routing interfaces in the system are configured as passive or non-passive.
all
When a level on an interface is configured as passive, the corresponding Hello packets are not sent or
received on that interface. Any packet that is received is ignored. As result of this no adjacency is
established.
Example
The following command configures vlan v1 as a level 2 passive interface
configure isis vlan v1 level-2 passive
History
This command was first available in ExtremeWare v6.1.8 IS-IS tech release and subsequently
incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
1276
Specifies the name of a VLAN.
Specifies all VLANs.
Specifies IS-IS level 1.
Specifies IS-IS level 2.
Specifies IS-IS level 1 and level 2.
Specifies passive.
Specifies non-passive.
ExtremeWare Software 7.3.0 Command Reference Guide