Configure Ospf Virtual-Link Authentication Password - Extreme Networks ExtremeWare Command Reference Manual

configure ospf virtual-link authentication password

configure ospf [vlan <vlan name> | area <area identifier> | virtual-link
<routerid> <area identifier>] authentication [simple-password <password> |
md5 <md5_key_id> <md5_key>| none | encrypted [simple-password <password> |
md5 <md5_key_id> <md5_key>]
Description
Specifies the authentication password (up to eight characters) or Message Digest 5 (MD5) key for one or
all interfaces in an area.
Syntax Description
vlan name
area identifier
routerid
password
md5-key_id
md5_key
none
Default
N/A.
Usage Guidelines
The md5_key is a numeric value with the range 0 to 65,536 or alphanumeric. When the OSPF area is
specified, authentication information is applied to all OSPF interfaces within the area.
Example
The following command configures MD5 authentication on the VLAN subnet_26:
configure ospf vlan subnet_26 authentication md5 32 test
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies a VLAN name.
Specifies an OSPF area.
Specifies a router identifier number.
Specifies an authentication password (up to 8 ASCII characters).
Specifies a Message Digest 5 key, from 0-255.
Specifies a numeric value from 0-65,536. Can also be alphanumeric
Disables authentication.
configure ospf virtual-link authentication password
1285