Extreme Networks ExtremeWare Command Reference Manual page 1006

Hide thumbs Also See for ExtremeWare:

Table of Contents

STP Commands

—This mode implements PVST+ in compatibility with third-party switches running this

version of STP. The STPDs running in this mode have a one-to-one relationship with VLANs, and

send and process packets in PVST+ format.

An StpdID is used to identify each STP domain. You assign the StpdID when configuring the domain.

An StpdID must be identical to the VLANid of one of the member VLANs in that STP domain, and that

VLAN cannot belong to another STPD.

These port modes are for STP ports, not for physical ports. When a physical port belongs to multiple

STPDs, it is associated with multiple STP ports. It is possible for the physical port to run in different

modes for different domains for which it belongs.

When the switch boots, it automatically creates a VLAN named default with a tag value of 1, and STPD

s0 with an StpdID of 1. The switch associates VLAN default to STPD s0. By default, all ports that belong

to this VLAN and STPD are in 802.1d mode.

Create a VLAN named marketing and an STPD named STPD1 as follows:

create vlan marketing

create stpd stpd1

The following command adds the VLAN named marketing to the STPD STPD1:

configure stpd stpd1 add vlan marketing

This command was first available in ExtremeWare 2.0.

This command was modified in ExtremeWare 6.2 to support STP port mode configurations.

Platform Availability

This command is available on all platforms.

ExtremeWare Software 7.3.0 Command Reference Guide

Extremeware 7.3.0