Idle States - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
1 Programming Basics

Idle States

Exiting System Programming
Use the information in
main menu (Menu Mode screen), or the Home screen from within a programming
screen.
Table 1-6.
To return to...
Previous Menu
Main Menu
Normal Call-
Handling
Idle States
Some programming procedures can be started only when the entire system, or
some part of it, such as a trunk or an extension, is idle (not in use). Some
procedures require that a trunk or extension be idle only at the instant of
programming. Lengthy procedures require the system, trunk, or extension to
remain idle until programming is completed. These procedures wait for the
system, trunk, or extension to become idle and then prevent the initiation of any
new calls. This condition is called forced idle.
NOTE:
If a procedure requires an idle condition, do the programming outside of
normal business hours.
If a procedure requires that the system be idle and the system is busy when you
begin, you see the screen shown in
Table 1-6 to return to the System Programming menu, the
Exiting System Programming
On the console, press...
Exit
Menu
Home
1
On the PC, press...
1
Figure 1-12.
Issue 1
April 1999
1-54