Udp Digit Absorption - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures
Uniform Dial Plan Routing

UDP Digit Absorption

Use this procedure to specify how many of the digits dialed (0 to 11) by the caller
should be absorbed (not sent over the trunk) by the system when a UDP call to a
non-local extension is made on an identified route. If the number is dialed without
a pool access code or without using a Pool button, therefore, the dialed digits
correspond to the non-local dial plan numbering. Digit absorption can be used to
modify the digits that are actually sent to the remote system.
Entries of 1 through 11 indicate that the system should not send the specified
number of digits, starting with the first digit dialed by the user.
NOTES:
Summary: UDP Digit Absorption
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
UDP pool routes must be programmed before you assign digit
absorption.
Do not use this procedure to overcome conflicts between local and
remote extension numbering. Such conflicts can result in numerous
problems with system features.
System Manager
Hybrid/PBX
Not required
Non-Local Dial Plan Administration Form in the
Installation Specification
0
0 to 11
No
No
Tables
Enter
Drop
Enter
Type route no. (1–4)
Type number of digits to absorb (0–11)
3
3
Dial pattern no. (1–20)
UDP Routing
Dial route no. (1–4)
Dial number of absorption digits (0–11)
Exit Exit Exit
Enter pattern no. (1–20)
Issue 1
April 1999
3-586
Enter Absorb
Exit
+ I