Table of Contents
Advertisement
MERLIN LEGEND Communications System Release 6.0
System Manager's Guide 555-660-118
6
Managing the System
Introduction to System Programming
Table 6–4.
Idle States
Idle State
Description
System
The entire system (every line and
Forced Idle
every extension) is idle. No calls
can be made or received.
Multiline phone users hear a signal,
indicating that the phone cannot be
used; display phone users see the
message Xhv‡)ÃT’†‡r€Ã7ˆ†’ ;
single-line telephone users do not
hear a dial tone.
Extension
No calls can be made or received
Forced Idle
on that phone or data terminal.
Multiline telephone users hear a sig-
nal, indicating that the phone cannot
be used; display phone users see
the message Xhv‡)ÃT’†‡r€Ã7ˆ†’ ;
single-line telephone users do not
hear a dial tone.
Line or Trunk
The line or trunk is idle only at the
Idle
instant of programming.
100D
Only the 100D module is idle.
Module Idle
Procedures
Select system mode (Lucent
Technologies only).
Identify system operator positions.
Renumber the system (Lucent
Technologies only).
Renumber modules (Lucent
Technologies only).
Identify extensions with voice signal
pairs for Voice Announce to Busy.
Restore backup file.
Assign call restrictions.
Assign pool dial-out restrictions.
Copy extension assignments.
Assign lines, trunks, or pools.
Assign labels to a Personal Directory.
Use centralized telephone
programming.
Identify loudspeaker paging extension
jack.
Assign trunks to pools.
Assign incoming or outgoing DID or tie
trunk type (Lucent Technologies only).
Specify tie trunk direction (Lucent
Technologies only).
Specify tie trunk E&M signal (Lucent
Technologies only).
Specify (Lucent Technologies only):
Board type
Frame format
Board signaling format
Board suppression format
Board facility compensation
Issue 1
February 1998
Page 6-12
Advertisement
Table of Contents
