Pool Routing - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures
Automatic Route Selection

Pool Routing

Use this procedure to identify the trunk pools on which to route calls to area codes
and/or exchanges included in ARS tables.
A maximum of six routes (numbered 1 through 6) can be specified for each
subpattern. Pool routing is programmed for Tables 1 through 16. Tables 17 and
18, the Default Toll and Default Local tables respectively, are factory set to the
main pool and can be changed.
NOTES:
Summary: Pool Routing
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
In Release 6.0 and later, when routing for ARS 10*** and 101****
equal-access calls (Interexchange Carrier or IXC) from a private
networked switch that is not connected to the public switched network
and only has private network tandem trunks, the private network tandem
trunks must be assigned to the main pool on the system where ARS is
dialed. The ARS access code for the caller's system must match that of
the system where the public switched network trunks are connected. For
this reason, consider using the same ARS access code for all systems
in the private network.
For Dial 0 and Special Numbers N11 calls (for example, 411 or 911)
routed from systems with only private trunks, the private trunks must be
assigned to the main pool, and the ARS access code of the remote
system must be prepended to the dialed number (see
page 3-572 and ''N11 Special Numbers Tables'' on page
access codes, therefore, should be the same.
System Manager
Hybrid/PBX
Not required
3f, Automatic Route Selection Tables
3g, Automatic Route Selection Default and
Special Numbers Tables
Not applicable
Not applicable
No
No
Tables
Dial table no. and pool route no.
Dial pool dial-out code
3
3
Sub A Pools or Sub B Pool
ARS
Enter
Issue 1
April 1999
3-554
''Dial 0 Table'' on
3-568). ARS
Enter
Exit Exit