Udp Facility Restriction Level - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures
Uniform Dial Plan Routing
Console Display/Instructions
6. Save your entry.
7. Select Pool.
UDP Pattern xx Route x:
Make a selection
Pool
FRL
Absorb
Digits
Exit
8. Enter a pool dial-out code, up to 4 digits, on which to route calls.
UDP Pattern xx Route x:
Enter pool dialout code
Backspace
Exit
9. Continue to enter a pool dial-out code for another route, or go to Step 10.
10. Save your entry.
11. Return to the System Programming menu.

UDP Facility Restriction Level

Use this procedure to assign a Facility Restriction Level (FRL) to each UDP route.
The FRL ranges from 0 (least restrictive) to 6 (most restrictive) and prevents users
from accessing the route. The FRL assigned to extensions and remote access
users is the opposite of the FRL assigned to routes, with 0 being the most
restrictive FRL, and 6 the least restrictive. A call will succeed if the extension's (or
remote access) FRL is greater than or equal to the facility's FRL.
Additional Information
Select Enter.
xx = pattern number entered in Step 3
x = route number entered in Step 5
Data
xx = pattern number entered in Step 3
x = route number entered in Step 5
Next
Dial or type [nnnn].
Enter
Select Next.
Select Enter.
Select Exit four times.
Return to Step 8. The next route number is
displayed on Line 1.
3
Issue 1
April 1999
3-582
PC
Ã