Call-By-Call Service Table - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures
PRI Facilities
Console Display/Instructions
6. Save your entry.
7. Return to the System Programming menu.

Call-by-Call Service Table

When a call is placed on a Call-by-Call B-channel group, a specific service is
selected. The selected service depends on the match between the dialed digits
and the table entries. A service must be specified; otherwise the entry is ignored.
The Call-by-Call table can contain up to 10 entries. Each entry can contain up to
10 patterns, each with a maximum of eight digits. If a dialed number matches two
patterns, the longer pattern takes precedence. For example, 212555 matches
both 212555 and 212, but the system will match the longer pattern. In addition to
patterns, the Call-by-Call table can be used to specify from 0 through 8 digits to be
deleted (the factory setting is 0).
If the last entry in the table is empty (that is, if no pattern is specified), this entry is
used as a default and matches any pattern and type of call.
If ARS (Hybrid/PBX only) is used, ARS selects the route. If the route points to a
Call-by-Call B-Channel group, Call-by-Call service selects the network service.
ARS Call-by-Call service is integrated according to the specified bearer capability
(voice, data, or both) for each feature. In addition, ARS digit deletion/addition may
help specify the service selected by the Call-by-Call feature. See
Route Selection'' on page 3-542
Beginning with Release 4.2, the following additional services are available:
MCI Toll Services for a DMS-250 or DEX600E switch type:
Local exchange carrier services available for a DMS-100 switch type:
— MCI PRISM
— MCI VNET
— DMS Private
— DMS OUTWATS
— DMS FX (foreign exchange)
— DMS Tie Trunk
Additional Information
Select Enter.
Select Exit four times.
3
for more information.
Issue 1
April 1999
3-249
PC
''Automatic