Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual page 618

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures
Optional Group Features
NOTES:
Summary: Group Calling Member Assignments
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
If a linear hunting pattern is indicated on the back of the system planning
form (6d), be sure to assign extensions to the group in the exact order
that they are shown on the form. The system searches for an available
member in the order in which you assign the extensions to the group.
A maximum of 32 calling groups with a maximum of 20 extensions per
group is allowed.
An extension can belong to only one calling group. A QCC cannot be a
member of a calling group. A delay announcement device should not be
programmed as a calling group member.
The extension status feature must be set to the Calling Group or CMS
mode before you assign members to the group.
on page 3-480.
In Release 6.1 and later, one non-local member may be in a calling
group. A calling group cannot contain both local and non-local members.
See the Network Reference for information.
System Manager
All
Not required
7c, Group Coverage
Not applicable
Extension numbers
Yes
No
Extensions
Members
Dial ext. no.
no.
See ''Extension Status''
3
More
Grp Calling
Dial calling group ext. no.
Enter Exit Exit
Type calling group ext.
Type ext. no.
Issue 1
April 1999
3-416
Enter
Exit