Basic System Operating Conditions; System Restart - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures

Basic System Operating Conditions

Basic System Operating Conditions
The procedures in this section are all related to the system, rather than to the
operation of telephones, operator positions, lines, or trunks. These are operating
conditions that must be set only once—when the system is new or when you reset
the factory settings.
NOTE:
You must reset the system time when Daylight Savings Time begins and
ends.
This section contains the following programming procedures:

System Restart

System Programming Position Assignment
System Language
Board Renumbering
Mode of Operation
Automatic Maintenance Busy
System Date
System Time
System Restart
!
CAUTION:
This procedure is to be performed by qualified support personnel only.
Use this procedure to perform a System Restart (cold start). All calls are dropped
when you perform this procedure. Existing system programming is saved.
Telephones with the Extension Status feature may lose toll restrictions as a result
of a System Restart.
Summary: System Restart
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
3
3
3
Qualified support personnel
All
Not required
Not applicable
None
Issue 1
April 1999
3-2