Surrogate Mode Programming - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
2 Programming with SPM

Surrogate Mode Programming

Table 2-16.
Feature
Voice Announce
Receive
Caller Number and
Name on Caller ID
Priority Call
Queuing
Tip/Ring
Functionality on
412 LS-ID-ETR
and
016 ETR Modules
Rotary Signaling
on Tip/Ring Ports
Surrogate Mode Programming
Surrogate mode allows qualified service personnel to perform system
programming at an offsite service location. The actual communications system
hardware does not have to be installed — the programmer needs a power supply,
carrier, processor, and a direct connection from the PC to the processor module.
By following a customer's set of completed planning forms, the system can be
programmed as if the appropriate modules, trunks, telephones, and other
communications equipment have been installed. When system programming is
completed, a system backup is performed to save the information on disk. This
backup disk is then taken to the new installation site and used with the Restore
option to provide complete system programming for a new communications
system.
Optional Programming after Upgrade to Release 7.0
Sequence
Extensions
Choose a button
Start
More More
VoiceAnnounce
LinesTrunks
Delay EntryMode
Extensions
Priority
Enter Group Priority (1–32)
Enter
next group, select Next)
Support
Enter Support Group
Enter
group, select Next)
Extensions
Type ETR tip/ring port
Enter
type
Enter
Extensions
rotary ext. no.
Dial ext. no.
Enter
ListFeat
More More
More
LS-ID
Type trunk no.
More
Grp Calling
Enter extension number of group
Enter
Enter extension number of group
(To program the next
Enter Exit
More More
ETR
Exit Exit
More More
RotaryEnabl
Enter Exit
2
Issue 1
April 1999
2-74
SysProg
Enter
More
(To program the
Exit
Exit Exit
Type ext. no.
Select port
Type
Exit