Single Renumbering - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures
System Renumbering

Single Renumbering

Use this procedure to assign a specified extension number to a telephone,
accessory, line, pool (Hybrid/PBX only), calling group, paging group, or Listed
Directory Number. Single renumbering is also used for Remote Access, Park, Idle
Line Access (Key and Behind Switch only), and Automatic Route Selection
(Hybrid/PBX only).
!
CAUTION:
Select Exit on the console, or
extensions. If you press Home, extensions may remain in the forced idle
condition (indicated when the LED next to each DSS button is on). To
restore extensions to their normal operating state, restart the system.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
Summary: Single Renumbering
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
3
on the PC, after renumbering
3
System Manager
All
System idle
2a, System Numbering: Extension Jacks
2b, System Numbering: Digital Adjuncts
2d, System Numbering: Special Renumbers
Not applicable
Old and new extension numbers
Yes
No
SysRenumber Single
no. Dial new ext. no.
Enter
Exit
Select item
Type new ext. no.
April 1999
Select item Dial old ext.
Enter Exit
Type old ext. no.
Issue 1
3-25