Uniform Dial Plan Facilities; Switch Identifiers - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures

Uniform Dial Plan Facilities

Console/Display Instructions
5. Enter the last trunk number in the block to copy to.
START at Trunk xxx To:
Enter ending trunk
number
Backspace
Exit
6. Save your entry.
7. Return to the System Programming menu.
Uniform Dial Plan Facilities
Release 6.0 and later systems, Hybrid/PBX mode only, provide support for
Uniform Dial Plan (UDP) facilities, private network tandem lines/trunks originating
at one or more other MERLIN LEGEND Communications Systems or DEFINITY
Communications Systems. Use the procedures in this section to program the
switch identifiers for private network trunks.

Switch Identifiers

Switch identifiers are 1- or 2-digit prefixes that appear in print reports and are
used by the system for transmission level determination, route checking, and to
identify calls. If your system uses private facilities, you must program switch
identifiers. Switch identifiers indicate the switch connected to the far end of a
private trunk.
The procedures in this topic allow you to add, change, and remove switch
identifiers.
Trunks connected to your system from the central office do not require identifiers.
They are, by default, correctly assigned a null identifier.
When a private networked trunk is deleted, it is assigned a null identifier, as are
trunks newly added to the system.
Additional Information
xxx = "start copy to" trunk entered
in Step 3
Dial or type:
Trunk number [nnn]
Slot and port number
Enter Logical ID number #[nnn]
Select Enter.
Select Exit three times.
* [sspp]
3
3
Issue 1
April 1999
3-103
PC
Ã