Voice Messaging System And Automated Attendant - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures
Auxiliary Equipment
Voice Messaging System and Automated
Attendant
Use this procedure to specify the touch-tone duration and the interval between
digits in codes sent between a voice messaging system and the communications
system. The touch-tone duration and interval between digit assignment must be
the same as those programmed on the voice messaging system.
In addition, this procedure can be used to specify the number of rings before a call
transferred to a local extension by the voice messaging system is sent to the
backup position for both integrated and generic VMI ports. The number of rings
cannot be programmed for individual voice messaging systems; the single setting
applies for all. Use the Group Type procedure in
page 3-405
NOTE:
This does not apply to calls transferred to a non-local extension. See the
Network Reference for information.
!
SECURITY ALERT:
See
Voice Messaging Systems'' on page A-14
with Transferring through Voice Messaging Systems'' on page A-12
Appendix
fraud.
Summary: Voice Messaging System and
Automated Attendant
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
to assign VMI ports as either integrated or generic.
''Security Risks Associated with the Automated Attendant Feature of
A, ''Customer Support
System Manager
All
Not required
See forms packaged with application
Touch-tone duration: 100 ms
Interval between digits: 50 ms
Number of rings before transfer sent to backup: 4
Touch-tone duration: 50 to 200 ms, in increments of
25 ms
Interval between digits: 50 to 200 ms, in increments of
25 ms
Number of rings before transfer sent to backup: 0 to 9
No
3
''Optional Group Features'' on
and ''Security Risks Associated
Information," for details on preventing toll
3
Issue 1
April 1999
3-308
in