System Forced Idle; Line Or Trunk Idle - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
1 Programming Basics
Idle States
System Busy Pls Wait
:nnnn S/P:ss/pp
Dial Code
Exit
Figure 1-12.
The screen changes to the appropriate programming screen when the system is
no longer busy.

System Forced Idle

When the entire system is forced idle, no calls can be made or received. The
following procedures can be performed only when the entire system (every line
and every extension) is idle:
Select system mode
Identify system operator positions
Renumber system
Renumber boards
Identify extensions with voice signal pairs for the Voice Announce to Busy
feature
Identify extensions that need voice and data features
Restore system programming information
Identify the Music-On-Hold jack
When the system is forced idle, the following occurs: Multiline telephone users
hear a signal, indicating that the telephone cannot be used; display telephone
users see the message Wait: System Busy; single-line telephone users do not
hear a dial tone.

Line or Trunk Idle

Because these procedures require the line or trunk to be idle only at the instant of
programming, the line or trunk is not forced idle (as described in the previous
Enter
System Busy Screen
nnnn = a previously entered extension
ss/pp = the slot and port number of the
busy extension
1
1
Issue 1
April 1999
1-55