Restore - Lucent Technologies MERLIN LEGEND Release 7.0 System Programming Manual

MERLIN LEGEND Communications System Release 7.0
System Programming 555-670-111
3 Programming Procedures
Memory Card
!
CAUTION:
The Memory Card may be write-protected to avoid the accidental erasure of
the backup files. Make certain this is not the case before you change the
Write-Protect Tab.
Card Failure
If the card is damaged, repeat the backup with a different card. If a backup is in
progress and fails, the system makes two additional attempts at the backup. At
the start of each attempt, a message appears with the percentage of the backup
that is completed. If the backup fails after three attempts, the screen shown below
appears. Repeat the backup procedure using a different file and/or Memory Card.
Memory Card Backup:
Backup Failure
Try a different file or
a new Memory Card.
Exit

Restore

Use this procedure to restore system conditions that were backed up onto a
translation memory card. The information in a backup file on the translation card is
copied to the system.
The restore procedure is necessary under the following conditions:
System RAM is corrupt.
A previously stored set of system conditions is preferred over the current
set.
Processor module is replaced.
After a System Erase (frigid start) has been performed.
System software has been reinstalled.
The Inspect feature (Inspct or
backup files on the memory card prior to initiating the restore procedure. The
attributes included on the Inspect screen are the filename, the time and day of the
file creation/update, the location of the system programming port, and information
about the system software release from which the backup was made.
If any type of programming is taking place at another extension when you begin
the restore procedure, the restore is canceled and the number of the first busy
3
3
) is available to view the attributes of the
Issue 1
April 1999
3-653