Configuring Your Device Based On A Site Profile - Cisco Catalyst 9300 Series Hardware Installation Manual

Configuring the Switch
Figure 59: Basic Settings - Device Management Settings

Configuring Your Device Based on a Site Profile

To ease your configuration tasks and save time, choose a site profile based on where your device may be
installed and managed in your network. Based on the site profile you choose, your device is automatically
configured according to Cisco best practices. You can easily modify this default configuration, from the
corresponding detailed configuration screens.
Choosing a site profile as part of Quick Setup allows you to configure your device based on the business needs
of your enterprise. For example, you could use your device as an access switch, to connect client nodes and
endpoints on your network, or as a distribution switch, to route packets between subnets and VLANs.
Table 32: Default Configuration Loaded with Each Site Profile (Access Switches)
Setting
Hostname
Spanning Tree Mode
VTP
UDLD
Error Disable Recovery
Port Channel Load
Balance
Single Access Switch Single Access Switch
(Single Uplink) (Single Port Channel
Uplink)
The hostname or device The hostname or device
name you provided as part name you provided as part
of Quick Setup of Quick Setup
RPVST+ RPVST+
Mode Transparent Mode Transparent
Enabled Enabled
Recovery mode set to Recovery mode set to
Auto Auto
Source Destination IP Source Destination IP
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
Configuring Your Device Based on a Site Profile
Single Access Switch
(Redundant Port Channel
Uplink)
The hostname or device
name you provided as part
of Quick Setup
RPVST+
Mode Transparent
Enabled
Recovery mode set to
Auto
Source Destination IP
93