Creating Fcip Profiles; Displaying Fcip Profile Information - Cisco MDS 9000 series Configuration Manual

Chapter 2 Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Creating FCIP Profiles

You must assign a local IP address of a Gigabit Ethernet interface or subinterface to the FCIP profile to
create an FCIP profile. You can assign IPv4 or IPv6 addresses to the interfaces.
example configuration.
Figure 2-9
IP address of Gigabit Ethernet
interface 3/1 = 10.100.1.25
To create an FCIP profile in switch 1 in
Command
Step 1
switch1# config terminal
switch1(config)#
Step 2
switch1(config)# fcip profile 10
switch1(config-profile)#
Step 3
switch1(config-profile)# ip address
10.100.1.25
To assign FCIP profile in switch 2 in
Command
Step 1
switch2# config terminal
switch2(config)#
Step 2
switch2(config)# fcip profile 20
switch2(config-profile)#
Step 3
switch2(config-profile)# ip address 10.1.1.1

Displaying FCIP Profile Information

Example 2-1
switch# show fcip profile
-------------------------------------------------------------------------------
ProfileId
-------------------------------------------------------------------------------
1
2
40
100
200
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)
Assigning Profiles to Each Gigabit Ethernet Interface
Switch 1
IP router
Displays FCIP Profiles
Ipaddr
10.10.100.150
10.10.100.150
40.1.1.2
100.1.1.2
200.1.1.2
IP
Network
Figure 2-9, follow these steps:
Purpose
Enters configuration mode.
Creates a profile for the FCIP connection. The
valid range is from 1 to 255.
Associates the profile (10) with the local IPv4
address of the Gigabit Ethernet interface (3/1).
Figure 2-9, follow these steps:
Purpose
Enters configuration mode.
Creates a profile for the FCIP connection.
Associates the profile (20) with the local IPv4
address of the Gigabit Ethernet interface.
TcpPort
3225
3226
3225
3225
3225
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
Configuring FCIP
Figure 2-9
Switch 2
IP router
IP address of Gigabit Ethernet
interface 3/1 = 10.1.1.1
shows an
2-9