Show Monitor Session - Cisco Nexus 5500 Series Command Reference Manual

show monitor session

show monitor session
To display information about the Switched Port Analyzer (SPAN) or Encapsulated Remote Switched
Port Analyzer (ERSPAN) sessions, use the show monitor session command.
Syntax Description session
all
brief
range range
status
Command Default
None
Command Modes
EXEC mode
Command History Release
5.2(1)N1(1)
Examples
This example shows how to display information about SPAN session 1:
switch# show monitor session 1
session 1
---------------
description
type
state
source intf
source VLANs
source VSANs
destination ports : Eth1/21
Legend: f = forwarding enabled, l = learning enabled
switch#
This example shows how to display a brief information about a SPAN session:
switch# show monitor session range 1 brief
session 1
---------------
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1328
show monitor session [session | all [brief] | range range [brief] | status]
(Optional) Number of the session. The range is from 1 to 18.
(Optional) Displays all sessions.
(Optional) Displays a brief summary of the information.
(Optional) Displays a range of sessions. The range is from 1 to 18.
(Optional) Displays the operational state of all sessions.
Note
Modification
This command was introduced.
: A Local SPAN session
: local
: down (No operational src/dst)
:
rx : Eth1/5
tx : Eth1/5
both : Eth1/5
:
rx :
:
rx :
This keyword applies only to SPAN sessions.
Chapter Show Commands
OL-27880-02