Running The Frusdr Load Utility - Intel SR4850HW4 - Server Platform - 0 MB RAM Product Manual

Running the FRUSDR Load Utility

NOTE
You can run the utility directly from the Intel® Server Platforms
SR4850HW4 and SR6850HW4 Deployment Toolkit CD or from USB flash
memory devices. If you choose to run the FRUSDR Load Utility from a USB
flash memory device, you must copy the utility from the Intel® Server
Platforms SR4850HW4 and SR6850HW4 Deployment Toolkit CD and follow
the instructions in the README.TXT file. For the latest version of the
FRUSDR package, see
http://www.intel.com/support/motherboards/server/SR4850HW4/
The FRUSDR Load utility must be run from a system executing DOS. Running it in a Window's
command-line provides incorrect results. Upon completing the programming of the FRU and SDR
areas, the server must be rebooted.
Follow these steps to run the FRUSDR Load Utility from the Intel® Server Platforms SR4850HW4
and SR6850HW4 Deployment Toolkit CD:
1. Boot the Intel® Server Platforms SR4850HW4 and SR6850HW4 Deployment Toolkit CD.
2. Exit the SCW
3. Type CD FRUSDR to change to the FRUSDR folder.
4. Run the utility by entering a command based on the following syntax:
frusdr [option] [/p]
NOTE
The frusdr command accepts single options only, except for allowing the /p
option with another option. For descriptions of the FRUSDR Load Utility
command-line options, see
below.
5. Manage the server management subsystem's product level FRU and SDR repository as
necessary.
6. Reboot the system by powering off the server, waiting until you hear the fans stop, and then
powering on the server. The reboot operation is necessary because the firmware must reload to
properly initialize the sensors after programming. Until the server is rebooted, the changes do
not take effect.
Intel® Server Platforms SR4850HW4 & SR4850HW4/M Product Guide
"FRUSDR Load Utility Command-line Options,"
109